TT-1602 5/16
10
11. Install the remaining doors.
11.1 Align the pins with the holes in the bulkhead
connection panel and install the rear door
(GM86106 or GM88902) on the alternator end of
the unit. See Figure 17 (item 1).
11.2 Align the pins with the holes in the base and install
the LH alternator panel (GM86105 or GM88917)
on the nonservice, a lternator side of the unit. See
Figure 17 (item 2).
11.3 Align the pins with the holes in the base and install
the exhaust panel (GM86096 or GM88913) on the
nonservice side of the unit See Figure 17 (item 3).
Attach the top of the exhaust panel to the
mounting brackets in the top rail and secure using
two wing nuts (X-276-9). See Figure 14 for more
detail.
11.4 Align the pins with the holes in the base and install
the LH panel (GM86095 or GM88897) on the
nonservice side, engine end of the unit. See
Figure 17 (item 4).
11.5 Align the pins with the holes in the base and install
the front panel (GM86094 or GM88896) on the
engine end of the unit. See Figure 17 (item 5).
11.6 Align the pins with the holes in the base and install
the RH panel (GM86093 or GM88895) to the
service side, engine end of the unit. See
Figure 17 (item 6).
11.7 Align the pins with the holes in the base and install
the RH alternator panel (GM93010 or GM93025)
to the service side, alternator end of the unit. Place
decal (GM93648) on RH alternator panel. See
Figure 17 (item 7).
11.8 Position the controller panel (GM93008) as
shown in Figure 17 and attach to the mounting
brackets in the top rail and secure using two wing
nuts (X-276-9). See Figure 14 for more detail.
12. Restore the generator set to service.
12.1 Reconnect the leads that were disconnected in
step 1.6. Position the controller into the controller
panel and secure using the existing hardware and
gasket(removedinstep1.7).
12.2 Check that the generator set master switch is in
the OFF position.
12.3 Reconnect the generator set engine starting
battery, the negative (--) lead last.
To Next Page
Loading...
