What to do if Kohler Inverter shows overspeed shutdown?
If your Kohler Inverter displays an overspeed shutdown, begin by resetting the controller. However, if the overspeed fault happens again, it's recommended to contact your distributor or dealer for further assistance.
What to do if the battery is weak in Kohler Inverter?
If the battery of your Kohler Inverter is weak or dead, recharge or replace it. Refer to the spec sheet for the recommended battery CCA rating.
What to do if Kohler Inverter shows low oil pressure shutdown?
If your Kohler Inverter experiences a low oil pressure shutdown, replace the low oil pressure switch. Also, check the engine for any potential damage.
What to do if my Kohler Marine Equipment generator set does not crank?
If your Kohler Marine Equipment generator set does not crank, there are several potential causes. It could be due to a weak or dead battery, in which case you should recharge or replace the battery. Check for reversed or poor battery connections. Inspect for loose connections or open circuits in the engine/controller connections, and verify the wire harness continuity. Replace the F2 fuse if it's blown; if it blows again, inspect the circuit and components, controller wiring, starter solenoid, and wiring for open grounds, loose connections, or pushed-out pins. Check the crank relay for 12VDC on lead 71N. Clean and retighten any poor ground connections. Inspect the starter and controller connections and operation, ensuring power to the controller.
Why my Kohler Marine Equipment cranks but does not start?
If your Kohler Marine Equipment generator cranks but does not start, begin by checking the fuel supply and fuel filters for any blockages. Inspect for loose or open connections at the fuel pump or fuel solenoid, and check the controller/engine wiring continuity. Ensure that the controller configuration settings are correct. Also, check for a locked rotor, which may be indicated by an overcrank fault shutdown.
What to do if my Kohler Inverter experiences a high temperature shutdown?
If your Kohler Inverter shows a high temperature shutdown, allow the engine to cool down completely. After it cools down, troubleshoot the cooling system to identify the root cause.
How to reduce noisy operation in my Kohler 6EKOD?
If your Kohler Marine Equipment generator is operating with noisy operation, check the exhaust system for leaks and replace as necessary. Retighten screws and replace rivets on any loose or vibrating sheet metal or housing.
What to do if the AC output circuit breaker is open in Kohler Inverter?
If the AC output circuit breaker is open in your Kohler Inverter, reset the breaker. Then, check for AC voltage on the generator side of the circuit breaker.
Why does my Kohler 6EKOD emit black or gray smoke?
If your Kohler Marine Equipment generator emits black or gray smoke, check the oil level. Also check compression, as the issue might be worn piston rings or valves.
How to troubleshoot erratic operation of my Kohler 6EKOD?
If your Kohler Marine Equipment operates erratically, adjust the governor stability. Clean the cylinder head to address potential carbon buildup in the engine. Check cylinder pressures with a leakdown test and inspect the valves and valve seats to ensure the engine valves are seating correctly.
General| AC Frequency | 60 Hz |
|---|---|
| Genset Power Rating | 6kW |
| Fuel Type | Diesel |
| Power Output | 6000 W |
| Engine Type | 4-cycle |
To Next Page
