To Next Page
S
Shawn PughSep 23, 2025
What to do if Kohler 40EFOZ Marine Equipment controller circuit board(s) inoperative?
- RreedshannonSep 23, 2025
If the controller circuit board is inoperative, replace the controller circuit board.
What to do if Kohler 40EFOZ Marine Equipment controller circuit board(s) inoperative?
If the controller circuit board is inoperative, replace the controller circuit board.
What to do if Kohler Marine Equipment fuel tank is empty?
If the fuel tank is empty or the fuel valve is shut off, add fuel and move the fuel valve to the ON position.
What to do if Kohler Marine Equipment controller fuse blown?
If the controller fuse is blown, replace it. If the fuse blows again, troubleshoot the controller.
What to do if Kohler Marine Equipment oil level low?
If the oil level is low, restore it and inspect the generator set for oil leaks.
What to do if AC output circuit breaker open in Kohler 40EFOZ Marine Equipment?
If the AC output circuit breaker is open, reset the breaker and check for AC voltage at the generator side of the circuit breaker.
What to do if Kohler 40EFOZ Marine Equipment thermostat inoperative?
If the thermostat is inoperative, replace the thermostat.
What to do if Kohler 40EFOZ Marine Equipment controller master or start/stop switch inoperative?
If the controller master or start/stop switch is inoperative, replace it.
What to do if Kohler Marine Equipment cooling water pump inoperative?
If the cooling water pump is inoperative, replace the water pump.
What to do if Kohler Marine Equipment has exhaust system leak?
If there is an exhaust system leak, inspect the exhaust system and tighten the loose exhaust system components.
How to reset fault switches on Kohler 40EFOZ?
If there is a fault shutdown, reset the fault switches and troubleshoot the controller.
Warns about accidental starting and provides procedures to prevent it during maintenance.
Details hazards associated with battery acid and gases, and proper handling procedures.
Covers warnings related to fuel flammability, combustible materials, and fire prevention.
Addresses carbon monoxide hazards and safety precautions related to the exhaust system.
Warns about hazardous voltage, electrical shock, and grounding requirements.
Highlights dangers from hot engine components and moving parts, and necessary precautions.
Provides safety notices for tasks like tightening hardware, servicing operating equipment, and sound shield removal.
Provides contact information for obtaining professional advice and service for generator power requirements.
Identifies maintenance and service parts for generator sets and advises obtaining a complete list from a dealer.
Identifies related literature available for generator sets, emphasizing trained personnel for installation or service.
Explains that specification sheets provide generator and engine information, referring to other manuals for details.
Details the alternator, excitation system, voltage regulator, and PMG advantages for generator sets.
Provides a diagram illustrating typical service points on the generator set.
Describes a kit providing remote monitoring of generator set condition from a remote location.
Explains the safeguard breaker's function in sensing output current and shutting off the AC voltage regulator.
Details the line circuit breaker's role in interrupting generator output during overload or short circuit.
Describes a kit with contacts that energize during operation to control various devices.
Outlines essential checks and inspections to perform before or at each generator set startup.
Recommends vessel inspection, especially the exhaust system, at the start of each boating season.
Presents angular operation limits for units covered in the manual, specifying continuous and intermittent angles.
States the generator set is intended for below-deck operation and outdoor use violates EU directives.
Instructs to operate the generator set under load weekly for one hour with an operator present.
Explains the operation of the Decision-Maker 3+ controller, including prime power mode.
Explains the operation of the expanded Decision-Maker 1 controller, including its controls and indicators.
Explains the operation of the standard Decision-Maker 1 controller, its controls, and indicators.
Covers general maintenance procedures, including safety warnings for servicing.
Provides a schedule for routine maintenance tasks at specified intervals.
Details procedures for inspecting and maintaining the generator set's cooling system.
Outlines inspection points for the exhaust system to ensure leakproof operation and safety.
Details procedures for preparing the generator set for storage of three months or longer.
General| Brand | Kohler |
|---|---|
| Model | 40EFOZ |
| Category | Marine Equipment |
| Language | English |
