10.4
Section 10
Reassembly
4. Attach the governor yoke to the cross shaft so the
curved section is up as marked. Secure with the
two screws. If a thread locking compound is not
preapplied, apply a small amount of Loctite
®
No. 266 or equivalent, to the screw threads
before installing. Torque the screws to 2.2 N·m
(20 in. lb.). See Figure 10-12.
Figure 10-14. Installing Governor Gear Assembly.
Figure 10-12. Installed Governor Yoke.
5. Install the first regulating pin with the head
down so it will contact the yoke. Install the
governor gear with the second regulating pin
and the flyweight assembly in/down onto the
governor shaft until it locks into position. Apply
a small amount of grease to the locking tab
thrust washer and install on top of the governor
gear so the tang is facing up in the 6 o’clock
position. See Figures 10-13, 10-14, and 10-15.
Figure 10-13. Regulating Pins and Governor Gear.
Figure 10-15. Installed Locking Tab Washer.
Install Crankshaft
1. Carefully slide the flywheel end of the crankshaft
through the main bearing in the crankcase. See
Figure 10-16.
Figure 10-16. Installing Crankshaft.
Tab
Position
Second
Regulating
Pin
First
Regulating
Pin
Governor
Gear
Governor
Gear
Assembly
To Next Page
Loading...
