Need help?Do you have a question about the Kohler COMMAND 11-16 HP and is the answer not in the manual?
Explains the meaning of Warning, Caution, and Note symbols used in the manual.
Details risks associated with gasoline, storage, and refueling to prevent fires and burns.
Warns about keeping clear of moving parts to prevent severe injury during operation.
Advises caution with hot engine components to prevent severe burns.
Alerts users to avoid touching electrical wires or components while the engine is running.
Notifies about chemicals in exhaust known to cause cancer or birth defects in California.
Warns against accidental engine starts causing severe injury or death, with disabling steps.
Explains the danger of odorless carbon monoxide from exhaust in confined areas.
Alerts to risks of explosive hydrogen gas from batteries during charging.
Highlights features like OHV design, lubrication, electronic ignition, and serviceability.
Specifies using high-quality detergent oil (API SG, SH, SJ+) and selecting viscosity based on temperature.
Advises using clean, fresh unleaded gasoline with appropriate octane rating.
Provides guidance on purchasing, storing, and using gasoline to minimize issues.
Lists approved gasoline blends (Gasohol, Gasoline/Ether) and those not approved.
Explains the importance of Model, Specification, and Serial numbers for parts and communication.
Explains emission compliance periods based on EPA and CARB standards.
Lists essential checks like oil, fuel, air cleaner, shrouds, and clutches before starting.
Offers tips for starting in cold weather, including oil, declutching, battery, and fuel.
Details how to start a cold or warm engine using throttle and choke controls.
Describes the correct method for pulling the starter rope to prevent damage.
Guides on using the electric starter switch and proper cranking procedures.
Outlines the procedure for stopping the engine, distinguishing between engines with and without shutdown solenoids.
Covers battery requirements and limitations on engine operating angles.
Advises on keeping cooling areas clean and warns against tampering with governor settings.
Presents a table of required maintenance tasks and their frequencies.
Details the steps for checking the oil level before each use, emphasizing accuracy.
Explains how to read the dipstick, acceptable levels, and the function of the Oil Sentryâ„¢.
Provides a step-by-step guide to draining and refilling the engine oil.
Outlines the process for replacing the oil filter, including priming it.
Details servicing the precleaner and replacing the paper element for optimal air intake.
Instructs on cleaning grass screens, cooling fins, and shrouds to prevent overheating.
Explains how to check, gap, or replace the spark plug for optimal ignition.
Describes the electronic magneto ignition system and its limited maintenance needs.
Warns about explosive gases during battery charging and safety precautions.
Advises on inspecting and replacing the in-line fuel filter when dirty.
Details checking oil level and type for engines with reduction gear units.
Lists initial checks for fuel system-related issues before adjusting the carburetor.
Guides on adjusting the low idle fuel needle and speed for optimal engine performance.
Provides a table identifying common engine problems and their potential causes.
Outlines steps for preparing the engine for long-term storage to prevent deterioration.
Explains how to identify and order genuine Kohler replacement parts using engine numbers.
Directs users to authorized service dealers for major repairs requiring specialized skills.
Explains model naming conventions and lists key engine specifications.
Lists conditions and items not covered by the 2-year limited warranty.
Informs how to locate and contact authorized service centers for warranty repairs.
Details coverage for emission-related parts and compliance with EPA/CARB standards.
Outlines the owner's duty for maintenance and avoiding abuse to maintain warranty validity.
Summarizes the warranty for the ultimate and subsequent purchasers regarding compliance.
Lists specific conditions like misuse, neglect, or unapproved modifications that void warranty.
Clarifies responsibility for maintenance and the use of authorized service centers for warranty work.
Provides contact information for sales and service inquiries in the U.S. and Canada.
To Next Page
General