10.15
Section 10
Reassembly
10
Install Oil Temperature Sensor
NOTE: Ensure part is clean, undamaged and free of
debris and make sure the electrical connector
has the seal in place.
1. Lightly oil the oil temperature sensor O-ring and
install the oil temperature sensor into the
breather cover.
2. Torque the sensor to 7.3 N·m (65 in. lb.). See
Figure 10-53.
Figure 10-53. Torque Oil Temperature Sensor.
3. Push the electrical connector on the oil
temperature sensor making sure a good
connection is made.
Install Oil Sentry™ (If So Equipped)
1. Apply pipe sealant with Tefl on
®
(Loctite
®
592
™
PST
®
Thread Sealant or equivalent) to the threads
of the Oil Sentry
™
switch and install it into the
breather cover. See Figure 10-54. Torque to
4.5 N·m (40 in. lb.).
Figure 10-54. Oil Sentry™ Switch (If So Equipped).
Oil Sentry
2. Connect the wire lead (green) to the Oil Sentry
™
terminal.
Install Blower Housing and Outer Baffl es
NOTE: Do not completely tighten screws until all
items are installed to allow shi ing for hole
alignment.
1. Slide the blower housing into position over the
front edge of the inner baffl es. See Figure 10-55.
Start a few of the screws to hold it in place.
Figure 10-55. Installing Blower Housing.
2. Position the outer baffl es and secure using the
four M6 hex fl ange screws Install two M6 screws
(20 mm long) into the intake port side of the
cylinder heads, including any li ing strap. Install
two M6 screws (16 mm long) into the exhaust
port side of the cylinder head. Install the two
short M5 screws (10 mm long) in the upper
mounting holes of the outer baffl es (into the
backing plate). See Figures 10-56 and 10-57. Be
sure any leads are routed out through the proper
off sets or notches, so they will not be pinched
between the blower housing and baffl es.
Figure 10-56. Tightening Outer Baffl e Screws.
To Next Page
Loading...
