Kohler K-5401 Installation Guide

6. Install the Remote Control - Residential
Determine the desired location of the remote control docking station.
Position the mounting bracket in the desired location and mark the location of the screw holes.
Remove the mounting bracket.
Drill 1/4″ holes at each of the screw locations.
Install an anchor in each of the holes.
Attach the mounting bracket to the wall using the two supplied screws.
Place the remote control on the docking station.
To make the remote control tamper resistant, install the supplied screw through docking station into
the remote control.
Install the batteries in the docking station (consult the Homeowners Guide for instructions if
needed).
Attach the docking station to the mounting bracket.
To pair the remote control to the toilet, consult the Homeowners Guide for instructions.
U
V
C
o
ver
S
to
p
Wa
ter tem
p
M
assage
S
p
iral
W
an
d
P
re
ssu
re
F
ron
t
R
ea
r
D
rye
r
C
le
an
S
e
at
Flu
sh
-e
co
Flush
-full Sea
t tem
p
Mounting Bracket
Docking
Station
Anchor
Screw
Remote Control
Docking Station
36"
(914 mm)
38" (965 mm)–
66" (1676 mm)
Kohler Co. 9 1226974-2-B

Kohler K-5401 Specifications

General

Brand	Kohler
Model	K-5401
Category	Toilets
Language	English