Preparations before the initial use
□ Confirm that the battery has been correctly installed in the "remote controller".
□
Confirm that there is no obstacle in front of the product.
□
the toilet complete the self check, after the product is powered on. During that time, it is normal to hear
rotating sound of the motor and bicker, or see the night light flicker. When the lighting stops flickering, the
self-check is completed.
□
When used for the first time, it will be in a default state:
Tee valve connection
Seat temp: mid
Wind temp: mid
Night light: On
Energy saving mode: On
Electrolyzed water function: On
Water pump: On (press and hold flush and front
wash button on toilet side panel, short “beep”
indicates water pump is on, long “beep”
indicates water pump is off.)
Front:
●
Water temp: mid
●
: mid
●
Position: mid
Rear:
●
Water temp: mid
Position: mid
●
: mid
●
Spiral:
●
Water temp: mid
●
: mid
●
Position: mid
□ Ensure if water inlet valve is OPEN.
To Next Page
Loading...
Need help?
General
