3. Connect the Water Supply
CAUTION: Risk of property damage. Do not push or pull on the water connection
between the seat and the water supply stop. This will prevent water leakage.
NOTICE: Use care to avoid cross threading or overtightening the connections. Unless other-
wise indicated, use an adjustable wrench to tighten one-quarter turn past hand-tight.
Connect the T-valve to the seat hose.
If needed, connect the supply hose to the supply stop.
Connect the supply hose to the T-valve.
Install the seat hose to the orange colored inlet.
IMPORTANT! The white cap must be in place on the side opposite the seat hose.
Connect the T-valve to the water inlet on the toilet tank.
Turn on the water supply.
Check all connections for leaks and make any adjustments as needed.
3
Or
Supply Stop
T-Valve
Filter
Filter
Hose
Supply Hose
1456686-X2-A Kohler Co.
Confirm the filter is in place. Install if needed.
To Next Page
Loading...
