Before You Begin
NOTICE: The K-99695 system controller is required to complete this
installation.
NOTICE: Custom shower configurations may not allow certain
system features to be enabled.
NOTE: For pre-programmed shower configurations, refer to the
guide on the K-99695 controller product page at www.us.kohler.com.
Observe all local plumbing, building, and electrical codes.
Read these instructions and determine all components and
installation locations before beginning installation.
A dedicated water heater, 80 gallon (302.8 L) or larger, per valve
is recommended for this installation.
A tankless (on-demand) water heater is not recommended for this
installation.
Drain requirements: The maximum flow rate per valve is 21
gal/min (79.5 l/min) at 45 psi (310.3 kPa). Use a minimum 3″ (76
mm) single drain, minimum 2″ (51 mm) multiple drains, or a
drain system capable of handling the maximum flow rate for one-
or two-valve systems.
Before Operating the System For the First Time:
Download and install the latest software for connected components.
This may take an hour or more to complete based on system
configuration and internet connection speed. Do not disconnect the
power from any components during software download and
installation.
1230865-2-A 2 Kohler Co.
To Next Page
Loading...
Need help?
General
