MODEL DESIGNATION
The Model number designates the cubic inch
displacement and the number of cylinders--Model
K181S; for example: designates 18 cubic inch
displacement, 1 designates single cylinder. The
letter suffii designates a specific version as follows:
SUffbC
Designation
EP
P
R
S
T
Generator Set
Pump Model
Gear Reduction
Electric Start
Retractable Start
ENGINE IDENTIFICATION
NUMBERS
When ordering parts, or in any communication
involving an engine, always give the Model,
Specification, and Serial Numbers of the engine.
The engine identification numbers appear on decal
(or decals) affixed to the engine shrouding. See
figure below. Include letter suffiies, if there are any.
MODEL NO.
SPEC. NO.
SERIAL NO.
REFER TO OWNER’S MANUAL
FOR OPERATlON/MAlNTENANCE
INSTRUCTIONS AND SAFETY
PRECAUTIONS.
KOHLER COMPANY
KOHLER WISCONSIN USA
Record your engine identification numbers on the
identification plate illustration for future reference.
PARTS ORDERING
The engine Specification, Model, and Serial numbers
are required when ordering replacement parts from
your Kohler Engine Service Dealer. These numbers
are found on the identification plate which is affixed
to the engine shrouding. Include letter suffixes if
there are any. See “Engine Identification Numbers”
above.
A/ways insist on genuine Kohler pans. All genuine
Kohler parts meet strict standards for fit, reliability,
and performance.
STORAGE
If the engine is to be out of service for approximately
two months or more, use the following storage
procedure:
1 .
2 .
3 .
Clean exterior surfaces of the engine.
Change oil when engine is still warm from
operation. See Changing Oil” on page 4.
Drain reduction gear unit, if so equipped, and
refill with same oil as used in engine for season
of operation.
4 . The fuel system must be completely emptied, or
the gasoline must be treated with a stabilizer to
prevent deterioration. If you choose to use a
stabilizer, follow the manufacturers
recommendations, and add the correct amount
for the capacity of the fuel system.
Fill the fuel
tank with clean, fresh gasoline. Run the ,engine
for 2-3 minutes to get stabilized fuel into the
carburetor.
To empty the system, run the engine until the
tank and system are empty.
5 . Remove the spark plug. Add one tablespoon of
engine oil into each spark plug hole. Install
plugs but do not connect plug leads. Crank the
engine two or three revolutions.
6 . Remove plug, cover hole with thumb and turn
engine over until piston is at top of stroke-
determined when pressure against thumb is
greatest.
7 . Store the engine in a clean dry place.
MAJOR REPAIR
Major repair information is provided in the Kohler
Single Cylinder Service Manual, available from your
Kohler Engine Service Dealer. However, major repair
generally requires the attention of a trained
mechanic and the use of special tools and
equipment. Your Kohler Engine Service Dealer has
the facilities, training, and genuine replacement parts
necessary to properly perform the service. For sales
and service assistance call l-800-544-2444 (U.S. and
Canada) or contact your Kohler Engine Dealer or
Service Distributor. They’re in the Yellow Pages
under ENGINES, GASOLINE.
14
To Next Page
Loading...
