Kohler TP-5353 - Engine Cranks, But Will Not Start Troubleshooting

TP-5353 8/94 Generator/Controller Troubleshooting 6-5
Engine Cranks, But Will Not Start
Engine cranks but will not start.
Is fuel low? Yes
No
Is LED3 lit?
No
Add fuel.
Yes
Yes
Replace circuit board.
Check circuit board
P2 harness and
connector pins. Is
harness defective?
No
Yes
Repair or
replace
harness.
Replace circuit board.
Are controller panel lights lit?
No
Repair or replace
harness and/or
components.
No
Yes
Check P1 harness and
connector pins. Is
harness defective?
Yes
Repair or replace
harness.
No
Replace circuit board.
Check bulbs. Are
bulbs burned out?
Yes
Replace
bulbs
No
Does engine starting circuit
checkout okay? Check for
battery voltage at ignition
coil (on gas/gasoline units)
or fuel solenoid/injector
pump/electronic governor
(on diesel units).
3-187
V
1
1. Fuse Terminal
Figure 6-4. Checking Condition of Fuse F2