To detach the brush, insert the tip of a small screwdriver into the corner notch and pry up
the brush.
Pool Preparation
- If the liner is brittle, damaged, or wrinkled, contact a qualified professional to perform the
necessary repairs or perform a liner replacement prior to using the pool vacuum.
- If you are using a saltwater pool, make sure all salt are dissolved before placing the pool
vacuum into the water.
OPERATION
1) Bring your pool vacuum to the side of your pool. Turn the switching knob clockwise
until it clicks to expose the water sensors. The light at the top will turn blue.
Immerse the pool vacuum into water, the light turns immediately to green and the
impeller will start to turn after 4-5 seconds.
Light Color
Blue Power On
(ready for operation)
Blue – Flash Battery level is running low
Green In operation
Green -Flash Battery level is running low.
Green light Off
Battery depleted
(need to be recharged)
Red Impeller stops
(impeller clogged).
To Next Page
