Komatsu D375A-5 - Table of Contents

5. CONTENTS FOREWORD
1-8
5. CONTENTS
FOREWORD
1. FOREWORD .................................................................................................................................................... 1-2
2. SAFETY INFORMATION................................................................................................................................. 1-3
3. INTRODUCTION.............................................................................................................................................. 1-5
4. PRODUCT INFORMATION ............................................................................................................................. 1-6
4.1 LOCATION OF NAMEPLATE FOR TRANSMITTER (TX. UNIT) ........................................................ 1-6
4.2 LOCATION OF NAMEPLATE FOR RECEIVER (RX. UNIT) ............................................................... 1-6
4.3 LOCATION OF NAMEPLATE FOR CONTROLLER............................................................................ 1-6
4.4 YOUR MACHINE SERIAL NUMBERS AND DISTRIBUTOR .............................................................. 1-7
SAFETY
6. GENERAL PRECAUTIONS ............................................................................................................................ 2-2
7. PRECAUTIONS FOR OPERATION .............................................................................................................. 2-12
OPERATION
8. GENERAL VIEW ............................................................................................................................................. 3-2
8.1 GENERAL VIEW OF MACHINE .......................................................................................................... 3-2
9. EXPLANATION OF COMPONENTS............................................................................................................... 3-4
9.1 TRANSMITTER (TX. UNIT) ................................................................................................................. 3-5
9.2 RECEIVER UNIT (RX. UNIT) ............................................................................................................ 3-12
9.3 CONTROLLERS ................................................................................................................................ 3-13
9.4 CHARGER ......................................................................................................................................... 3-14
9.5 ROTATING LAMPS ........................................................................................................................... 3-15
10. HANDLING RADIO CONTROL ................................................................................................................... 3-16
10.1 FLOW CHART FOR STARTING, OPERATING USING RADIO CONTROl .................................... 3-17
10.2 FLOW CHART FOR STOPPING OPERATION USING RADIO CONTROL.................................... 3-18
10.3 DETAILS OF PROCEDURE FOR RADIO CONTROL OPERATION .............................................. 3-19
11. PRECAUTIONS WHEN OPERATING RADIO CONTROL ......................................................................... 3-25
12. Operation using radio control................................................................................................................... 3-26
12.1 Moving off ........................................................................................................................................ 3-26
12.2 Steering (changing direction of travel) ............................................................................................. 3-27
12.3 Work equipment (blade RAISE/LOWER/FLOAT, tilt left/right, ripper UP/DOWN, ripper tilt in/back)3-27
12.4 Acceleration/deceleration................................................................................................................. 3-27
12.5 Stopping (braking)............................................................................................................................ 3-28