8.
Insert
the key in the starting switch, turn the key to ON po-
sition (B), then perform the following checks.
9.
On the input display screen displayed on the monitor, input
the password and push input confirmation switch F6.
If
a password is set, the input display screen will be indi-
cated on the monitor screen.
REMARK
Contact your Komatsu distributor for details of the method
of setting, changing, or canceling the password.
10.
Perform the following inspection on the machine monitor.
1)
The buzzer sounds for approximately 2 seconds and
the camera image is displayed.
2)
The following caution lamps and meters light up for
approximately 2 seconds.
•
Radiator coolant level caution lamp (6)
• Charge level caution lamp (7)
• Engine oil pressure caution lamp (8)
If any lamp does not light up or the buzzer does not
sound, there is probably a failure in the machine moni-
tor, so ask your Komatsu distributor for repair.
3)
After approximately 2 seconds, the screen will change
to the preset (speed range to start) display screen.
Then, it will switch to the standard screen.
• Engine coolant temperature caution lamp (9)
• Engine coolant temperature gauge (10)
• Power train oil temperature caution lamp (11)
• Power train oil temperature gauge (12)
• Hydraulic oil temperature caution lamp (13)
• Hydraulic oil temperature gauge (14)
• Fuel level caution lamp (15)
• Fuel gauge (16)
MACHINE OPERATIONS AND CONTROLS OPERATION
3-152
To Next Page