SEN04932-01
00-200 30 D65EX, PX, WX-16
200 Foreword and general information
Method of disassembling and connecting push-pull type coupler
Type 2
1. Disconnection
1) Hold the tightening portion and push body
(7) straight until sliding pr
evention ring (6)
contacts contact surface (a) of the hexag-
onal portion at the male end. (Fig. 6)
2) While holding the condition of Step 1), turn
l
ever (8) to the right (clockwi
se). (Fig. 7)
3) While holding the condition of Steps 1)
and 2), pull out whole body (7) to discon-
nect i
t. (Fig. 8)
2. Connection
q Hold the tightening portion and push body
(7) straight until sliding prevention ring (6)
contacts contact surface (a) of the hexag-
onal portion at the male end. (Fig. 9)
To Next Page
