SEN04932-01
D65EX, PX, WX-16 00-200 31
200 Foreword and general information
Method of disassembling and connecting push-pull type coupler
Type 3
1. Disconnection
1) Hold the tightening portion and push body
(9) straight until sliding pr
evention ring (8)
contacts contact surface (b) of the hexag-
onal portion at the male end. (Fig. 10)
2) While holding the condition of Step 1),
p
ush cover (10) straight until it contac
ts
contact surface (b) of the hexagonal por-
tion at the male end. (Fig. 11)
3) While holding the condition of Steps 1)
and 2
), pull out whole body (9) to discon-
nec
t it. (Fig. 12)
2. Connection
q Hold the tightening portion and push body
(9) straight until the sliding prevention ring
contacts contact surface (b) of the hexag-
onal portion at the male end. (Fig. 13)
To Next Page
