Komatsu HD465-8 User Manual

3.
Remove mud and dirt around the breather (1).
4.
Remove the breather (1).
Take care to prevent dirt from entering through the mount-
ing section of the breather.
5.
Remove the bolt (2) of breather (1).
6.
Remove the cover (3).
7.
Rinse the breather (4) in clean diesel fuel or flushing oil,
and remove the dirt inside.
8.
Install the breather element (4).
9.
Install the cover (3) and bolt (2).
10.
Install the breather (1).
11.
Remove the body pivot pin.
12.
Lower the dump body.
METHOD FOR CLEANING STEERING AND HOIST OIL TANK BREATHER
kk
WARNING
Immediately after the engine is stopped, its parts and oil are still very hot and may cause burn injury.
Wait for the temperature to go down, and then start the work.
1.
Remove mud and dirt around the breather.
2.
Remove the breather.
Take care to prevent dirt from entering through the mount-
ing section of the breather.
3.
Remove the nut (1) of breather assembly.
4.
Remove the cover (2).
5.
Rinse the breather (3) in clean diesel fuel or flushing oil,
and remove the dirt inside.
6.
Install the breather element (3).
7.
Install the cover (2) and nut (1).
8.
Install the breather assembly.
MAINTENANCE MAINTENANCE PROCEDURE
4-39

Komatsu HD465-8 Specifications

General

Brand	Komatsu
Model	HD465-8
Category	Trucks
Language	English