2.
Remove the nut (2) of breather assembly (1).
3.
Remove the cover (3).
4.
Replace the breather element (4) with a new one.
5.
Install the cover (3) and nut (2).
6.
Lower the dump body.
METHOD FOR LUBRICATING
1.
Stop the engine.
2.
By using a grease pump, pump in grease through the grease fitting shown by arrow.
3.
Check visually that the greasing has been performed properly.
4.
After greasing, wipe off any old grease that is pushed out.
Transmission mount (1 place)
Automatic suspension link (1 place each of right and left)
(if equipped)
MAINTENANCE PROCEDURE MAINTENANCE
4-58
To Next Page
Loading...
Need help?
General
