Komfovent DOMEKT R 300 V Installation And Service Manual

32 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

DOMEKT

EN

Installation and service Manual

Table of Contents

Other manuals for Komfovent DOMEKT R 300 V

User Manual46 pages

Installation Manual44 pages

Questions and Answers:

M
Matthew ByrdAug 16, 2025
How to fix low supply air flow in my Komfovent Fan?
- B
  Brandy BoyerAug 16, 2025
  If you're experiencing low supply air flow with your Komfovent Fan, here are a few things to check: * Make sure your air filters aren't dirty. If they are, replace them. * Check for any obstructions in your air ducts, dampers, or inlet/exhaust openings. * If you're using VAV air flow control, ensure the pressure sensors are properly connected. If VAV isn't needed, switch to CAV or DCV in the settings. * If the above doesn't resolve the issue, the supply air fan may not be working, and you should contact authorised service.
E
egreenAug 19, 2025
How to troubleshoot low extract air flow in my Komfovent Fan?
- J
  joyhernandezSep 12, 2025
  If you're experiencing low extract air flow with your Komfovent Fan, here are a few things to check: * Make sure your air filters aren't dirty. If they are, replace them. * Check for any obstructions in your air ducts, dampers, or inlet/exhaust openings. * If you're using VAV air flow control, ensure the pressure sensors are properly connected. If VAV isn't needed, switch to CAV or DCV in the settings. * If the above doesn't resolve the issue, the extract air fan may not be working, and you should contact authorised service.
S
Shawn TrevinoAug 25, 2025
Why is the return water temperature low in my Komfovent Fan?
- J
  John HarrisAug 25, 2025
  If you are experiencing a low return water temperature in your Komfovent Fan, consider the following: * Verify that there is hot water in the water heater system. * Check if the circulation pump is working correctly. * Ensure the water control valve is opening properly. * Confirm that the return water temperature sensor is correctly installed as per the installation manual. If issues persist, contact your installer or authorized service.
M
Monica ThomasAug 27, 2025
How to fix a heat exchanger failure in my Komfovent Fan?
- M
  Melissa JonesAug 27, 2025
  If you are experiencing a heat exchanger failure in your Komfovent Fan, here are some things to check: * For DOMEKT R devices, check for any obstructions preventing the rotor heat exchanger from rotating and inspect the rotor belt for tears. * For DOMEKT CF units, if the air bypass damper of the counter-flow heat exchanger is malfunctioning, contact authorised service.
M
Michael WoodAug 30, 2025
Why is the supply air temperature low in my Komfovent Fan?
- M
  mburchAug 30, 2025
  If the supply air temperature from your Komfovent Fan is too low, it could be due to: * Integrated heaters not working: Contact authorised service. * Additional heating/cooling devices faulty or incorrectly installed: Contact the company that installed or sold the equipment. * Faulty air temperature sensor: Contact authorised service.
N
Nancy DuffySep 2, 2025
What causes high supply air temperature in Komfovent Fan?
- M
  mwangSep 2, 2025
  If the supply air temperature from your Komfovent Fan is too high, it could be due to: * Integrated heaters malfunctioning: Contact authorised service. * Additional heating/cooling devices malfunctioning or incorrectly installed: Contact the company that installed or sold the equipment. * Faulty air temperature sensor: Contact authorised service.
A
Alexander WrightSep 4, 2025
Why is the heat exchanger icing up in my Komfovent Fan?
- V
  veronicamaysSep 4, 2025
  If your Komfovent Fan's heat exchanger is icing up, it could be due to: * Malfunctioning antifreeze protection: Check the antifreeze protection settings and ensure any external pre-heater being used is working correctly. * Antifreeze protection switched off: Verify the antifreeze protection settings. If you're not using an integrated or external pre-heater, you can't use a device with a counter-flow heat exchanger when the outside temperature drops below -4 °C.
C
Carlos ReidSep 7, 2025
What causes low heat exchanger efficiency in Komfovent Fan?
- W
  Wyatt BurnettSep 7, 2025
  If a message indicates low heat exchanger efficiency in your Komfovent Fan, here are some potential causes and solutions: * If air is being extracted through an additional branch (only for DOMEKT R devices), and that's not needed, close the fifth branch. Ensure any air closing damper in the auxiliary extraction duct is completely closed. * If the supply air volume significantly exceeds the extract air volume and this difference isn't required, unify the air flow settings. * If the unit door isn't fully closed, leading to mixed air flows, ensure the door is firmly pressed shut and that the gaskets aren't worn.
E
edwin78Sep 10, 2025
What triggers an internal fire alarm in my Komfovent Fan?
- C
  Chad FergusonSep 10, 2025
  If your Komfovent Fan is showing an internal fire alarm, it may be triggered because: * The internal air temperature is above 50°C: Locate the heat source in the ductwork or unit. * Faulty temperature sensor: Contact authorised service.
E
emilytaylorSep 12, 2025
What to do, if my Komfovent Fan indicates clogged air filters?
- J
  Jason WilliamsSep 12, 2025
  If your Komfovent Fan indicates clogged air filters, switch off the device and replace the air filters. After replacement, delete the message.

Komfovent DOMEKT R 300 V Specifications

General

Mounting	Vertical
Operating temperature	-20°C to +40°C
Heat exchanger type	Counterflow
Power supply	230 V
Filter class	G4

Related product manuals

Komfovent DOMEKT R 400 V

Komfovent DOMEKT R 450 V

Komfovent DOMEKT R 500 V

Komfovent DOMEKT R 700 V

Komfovent DOMEKT R 400 H

Komfovent DOMEKT R 600 H

Komfovent Domekt R 150 F

Komfovent DOMEKT R 250 F C6

Preview: Komfovent Domekt REGO

Komfovent Domekt REGO

Preview: Komfovent DOMEKT series

Komfovent DOMEKT series

Komfovent VERSO R 1300 F

Komfovent VERSO R 2000 F