What to do if return water temperature in water heater dropped lower allowable level in Komfovent Fan?
If the return water temperature in the water heater dropped lower than the allowable level in your Komfovent Fan, check the circulation pump and heating system condition, and the heating valve actuator performance.
What to do if temperature of the air passing through plate heat exchanger, dropped lower allowable level in Komfovent KOMPAKT REGO 1200 PE-EC Fan?
If the temperature of the air passing through the plate heat exchanger dropped lower than the allowable level in your Komfovent Fan, check the by-pass damper condition and actuator performance. It is recommended to decrease the ventilation level.
What to do if Komfovent KOMPAKT REGO 1200 PE-EC Fan received fire alarm signal from the building fire system?
If your Komfovent Fan received a fire alarm signal from the building fire system, restart the unit from the control panel when the fire alarm signal disappears.
Details required clearance for unit installation, service, and inspection.
Guidance on connecting modular sections of air handling units for proper assembly and sealing.
Instructions for properly connecting pipework to heating coils, ensuring support and load distribution.
Covers periodic checks for exchangers, fans, heaters, dampers, filters, and sensors for optimal performance.
Specific inspection procedures for air heaters, dampers, filter clogging, and pressure sensor settings.
Procedures for connecting unit sections and ensuring correct electric power supply and earthing.
Details on connecting external devices to the unit's connection boards.
Guidelines for correctly installing supply air and water temperature sensors in ducts and pipes.
Instructions for mounting the control panel in a suitable room environment and connecting it to the unit.
Explains unit control system components, panel operation, startup, and status indications.
How to view operating parameters and adjust ventilation levels and settings on the control panel.
Configuration options for unit operation modes, air volume control, temperature maintenance, and scheduling.
Covers remote control, ventilation correction, pump control, cooling recovery, and PC control features.
To Next Page
General