komoder FOCUS III - Touch Screen Manual Controller Interface Introduction

Air Strength
Speed
Width
4D Strength
1 2
1 2
1 2
1 2
1 2
3 4
1 2
Auto
Min
Manual
TESTING
READY TO FINISH
ZEROⅠⅠ
M
1312
Air Strength
Speed
Width
4D Strength
1 2
1 2
1 2
1 2
1 2
3 4
1 2
Auto
Min
Manual
TESTING
READY TO FINISH
ZEROⅠⅠ
M
12 3
4
5
6
7
89 10
11 12
13
14 15
16 17
18 19
20 21
22
Touch screen manual controller interface introduction Touch screen manual controller interface introduction
Note: the specific display shall prevail in kind!
6.Massage robot adjustments:
·The massage robot can be adjusted in the Spot and Partial state.
7.Mode:
·Turn on / off the pneumatic massage function.
8. Intensity:
·The function of regulating air pressure intensity
9.Sole roller:
·Turn on / off the sole roller massage function.
10.Heat:
·Turn on / off the heat massage function.
11.Power key:
·Turn on / off the massage chair.
12.Pause:
·Pause / Start the massage function.
13.Shoulder position adjustment:
·Manually adjust the massage shiatsu point of human shoulder position.
14.Calf down:
·Adjust the calf frame down.
15.Calf up:
·Adjust the calf frame up.
16.Seat-down:
·Adjust the backrest frame down and the calf frame up.
17.Seat-up:
·Adjust the backrest frame up and the calf frame down.
18.Zero gravity I:
·Adjust Zero gravity I.
19.Zero gravity II:
·Adjust Zero gravity II
20.Timing:
·Adjust the timing point.
21.Voice:
·Wake up or switch on/off the intelligent voice control.
22.Auto mode：
· Recovery, Relax, Neck & Shoulder, Waist Automatic massage functions include
Swing, Stretch, Hip lift, Beauty Care, Restoration, Meridian Treatment; More
Programs (Back SPA, Comfort massage, Full body massage, Spine care,
Sedentary pressure release, Back and waist massage).
23.Health detection:
·Detect the heart rate, blood oxygen and fatigue index levels.
24.Calf Knead:
·Press this button to start or stop the calf rubbing
23 24
1.LCD Screen
·Display all massage functions.
2.Technique:
·Massage techniques include six simulation massage techniques including Knead,
Tap, Knead and Tap, Shiatsu, Knock, Massage.
3.Position:
·There are five massage positions to select from: Spot, Partial, Full, Upper and
Lower.
4.Speed:
·In the Manual mode, speed is adjustable in five gears.
5.Width:
·In the Manual mode, the width adjustable of three gears for Tap, Shiatsu, Knock
and Massage, as well as Stop functions.