Kong Leef - Safe Usage and Product Limitations; Anchor Point Resistance Judgment; Prohibition of Modifications and Repairs; Testing and Quality System

rubbing against the rock face, etc..).
F) Resistance of anchors point, either natural or xed into the rock, is not always
granted and therefore it is essential for the user to carefully judge the situation
beforehand to guarantee adequate protection.
G) It is strictly forbidden to modify and/or repair the product: The Manufacturer
shall not be held liable for any damages, injuries or death caused by: improper
use, product modications, repairs by unauthorized persons or use of non-original
spare parts
H) During transportation avoid exposure to U.V. radiations and sources of heat
and avoid contact with chemical reagents or other corrosive substances, and
adequately protect any pointed or sharp parts. Warning: never leave your
equipment in a car under the sun!
I) For the sake of your own safety, it is essential to make sure that the product
was sold to the public: complete, in their original packaging and with the relative
information. It is compulsory for dealers selling products in countries other than the
original destination to check and supply the translation of this information.
L) This product has been tested and inspected piece by piece in conformity with the
Quality System certied to the UNI EN ISO 9001 international standard. Personal
protective equipment is certied by the notied body indicated in the relevant
product instructions. Warning: laboratory tests, inspections, information and
norms do not always manage to reproduce what actually happens in practice
so that the performances under real conditions when using the product in
a natural environment can often differ considerably. The best information
can be gained by continual practice under the supervision of skilled and
qualied instructors.
2 – WORKS AT A HEIGHT
Additional information for protective equipment against falls from a height
For the sake of safety in case of falls from a height, it is essential to:
assess the risks and make sure that the whole safety system, where this device is
only a component, is reliable and safe;
- prepare a rescue plan to deal with any emergencies possibly arising while the
device is being used,
- make sure that work is done in such way as to reduce potential falls and
relevant heights to a minimum,
- make sure that the fall arrest systems conform to the EN 363 standard, and
especially that:
- the anchor point conforms to the EN 795 norm, guarantees minimum strength
of 12 kN and is placed preferably above the user,
- that the parts being used are suitable and certied conforming to the standards
applicable to the specic works at a height that you are going to perform.
Important: A fall arrest device mandatorily requires the use of a complete harness
as per applicable norms.
3 – MAINTENANCE AND STORAGE
Product maintenance consists of:
- cleaning: frequently wash the product with lukewarm (max. 40°C) drinking-water
where necessary, you can also add some gentle detergent. Rinse and leave to dry
naturally away from direct sources of heat, do not centrifuge.
- disinfection (if necessary): soak the product for an hour in lukewarm water
CS
DA
DE
EL
EN
ES
FI
FR
IT
NL
PT
RU
SV