Kongskilde TRL 20 - User Manual

Other manuals for Kongskilde TRL 20

Questions and Answers

B
Brittany NelsonAug 19, 2025
What to do if conveying stopped but Kongskilde Blower continues to run?
- M
  Mary BrownAug 19, 2025
  If the conveying has stopped but the Kongskilde Blower continues to run, it could be due to a pipe blockage or the rotary valve rotor being blocked by impurities in the material. First, close the intake shutter at the feed to see whether the blower itself is able to clear the system. If this doesn't work, you'll need to dismantle and empty the piping. Also, remove any impurities blocking the rotary valve rotor and check if the rotor has been damaged.
T
Taylor MillsSep 3, 2025
Why has my Kongskilde Blower stopped conveying but continues to operate?
- M
  Mrs. Joyce FranklinSep 3, 2025
  If your Kongskilde Blower continues to operate but conveying has stopped, it could be due to a pipe blockage. In this case, close the intake shutter at the rotary valve to see if the blower can clear the piping itself. Another cause might be that the rotary valve rotor is blocked by impurities in the material. If the blower can't clear the blockage, dismantle and empty the piping, remove any impurities, and check the rotor for damage.
N
Nathaniel StephensNov 10, 2025
Why is the Kongskilde Blower capacity poor?
- T
  Tyler HobbsNov 10, 2025
  The Kongskilde Blower's capacity might be poor due to several reasons. The feed may not be correctly adjusted, or the piping could be incorrectly installed. The rotation direction of the blower or rotary valve might be incorrect, or the material could be blown into a container with an inadequate air outlet. Other potential causes include worn seals in the rotary valve, slack or worn-out V-belts, an intake regulator shutter that cannot move freely, or a feed that doesn't match the blower. To resolve this, ensure the feed is correctly adjusted, the piping is properly installed, the rotation direction is correct, the container has sufficient air outlet, the seals are in good condition, the V-belts are tightened or replaced, the intake regulator shutter moves freely, and the feed matches the b...
J
joshualewisNov 25, 2025
What to do if my Kongskilde Blower has poor capacity?
- V
  Victor BrownNov 25, 2025
  Several factors can cause poor capacity in your Kongskilde Blower. The feed might not be correctly adjusted. The piping might be incorrectly installed. The rotation direction of the blower (or rotary valve) might be incorrect, so change the direction of rotation. If the material is being blown into a container with an inadequate air outlet, open the container to allow air to escape. Other potential causes include worn seals in the rotary valve (replace them), V-belts that are too slack or worn out (tighten or replace them), an intake regulator shutter that cannot move freely (release it from the start position or clean impurities), a mismatch between the rotary valve/venturi and the blower (use the correct feed), or the rotary valve/venturi pointing in the wrong direction (reverse the feed...