Print Media3-6
DO NOT use envelopes that have
îš„ Sticky flaps
îš„ Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for seal-
ing
îš„ Transparent windows
îš„ Too rough of a surface
îš„ Material that will melt, vaporize, offset, discolor, or emit dangerous fumes
îš„ Been presealed
Label
A sheet of labels consists of a face sheet (the printing surface), adhesive, and
a carrier sheet:
îš„ The face sheet must follow the plain paper specification.
îš„ The face sheet surface must cover the entire carrier sheet, and no adhe-
sive should come through on the surface.
You can print continuously with label sheets. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
Try printing your data on a sheet of plain paper first to check placement.
Check your application documentation for more information on printing labels.
Use label sheets that are
îš„ Recommended for laser printing
DO NOT use label sheets that
îš„ Have labels that easily peel off or have parts of the label already removed
îš„ Have backing sheets that have peeled away or have exposed adhesive
" Labels may stick to the fuser, causing them to peel off and media
misfeeds to occur.
Capacity Tray 1 Up to 50 sheets, depending on their thick-
ness
Tray 2 Not supported
Orientation Face up
Driver
Media Type
Labels
Duplexing Not supported
To Next Page
Loading...
Need help?
General
