bizhub 754e/654e 1-16
1.4 Miscellaneous
1
IPsec setting
This machine offers a choice of two authentication methods of [Pre-Shared Key] and [Digital Signature] for
authenticating the remote machine with which to communicate.
When [Pre-Shared Key] is to be used, control the pre-shared key appropriately to ensure that it is not leaked
to any third party other than the remote machine with which to communicate.
[Digital Signature] has a higher security strength than [Pre-Shared Key].
CS Remote Care function
CS Remote Care is a system that manages the machine through transmission and reception of various types
of data for managing the machine between the machine and the CS Remote Care center computer via a tele-
phone/fax line, a network, or E-mail.
When the Enhanced Security Mode is set to [ON], the following functions are no longer usable: instructing to
rewrite the firmware, sending and receiving account counter information, rewriting settings of the machine,
and the Counter Remote Control function.
Terminating a Session and Logging out
The machine allows the operator to automatically log out from or terminate a session, if it is unable to detect
an operation on the control panel or a communication packet on the network.
The following shows the setting range and the default setting of each function. Set the time according to the
environment in which the machine is used.
The administrator of the machine should explain to the user that the following settings are made. The admin-
istrator of the machine should also explain to the user immediately as soon as the setting has been changed.
Authentication error during external server authentication
If a user is unable to log in successfully during user authentication using the external server authentication,
possible causes include the status of connection to the external server, the condition of the external server
(the server is down), and the status of user registration with the external server such as the number of users
to be controlled by the machine reaching its limit and the user password quality on the external server.
The administrator of the machine should check these points and make the appropriate settings.
Function name/software, etc Description
System Auto Reset Setting range
• [1] to [9] minutes, Default setting: [1] minute
Setting procedure
• [Utility] ö [Administrator Settings] ö [System Settings] ö [Reset
Settings] ö [System Auto Reset]
Auto Logout
(PageScope Web Connection)
Setting range
• [Admin. Mode Logout Time]: [1] to [60] minutes
Default setting: [10] minutes
• [User Mode Logout Time]: [1] to [60] minutes
Default setting: [60] minutes
Setting procedure
• Start the PageScope Web Connection and, in the Administrator
Mode, select [Security] ö [Auto Logout].
PageScope Data Administrator Default setting: [60] minutes (No change can be made in the setting)
The time setting represents consideration for the time-consuming
task, such as downloading the registered information. Be careful
about leaving your seat, because the time setting is rather long.
To Next Page
Loading...
Need help?
General
