What to do if image quality problem is not corrected after Gradation Adjust on Konica Minolta All in One Printer?
If you're still experiencing image quality issues with your Konica Minolta All in One Printer after running Gradation Adjust, try adjusting the D Max Density.
How to fix poor color reproduction performance on Konica Minolta BIZHUB C250?
If the color reproduction performance of your Konica Minolta All in One Printer is poor, perform Gradation Adjust.
What to do if Max or Highlight values remain outside specified ranges after adjustment on Konica Minolta All in One Printer?
If the Max or Highlight values remain outside the specified ranges after adjustment on your Konica Minolta All in One Printer, perform D Max Density.
What to do after the IU has been replaced on Konica Minolta BIZHUB C250?
After replacing the IU on your Konica Minolta All in One Printer, perform Gradation Adjust.
What to do after the Image Transfer Belt Unit has been replaced on Konica Minolta BIZHUB C250?
After replacing the Image Transfer Belt Unit on your Konica Minolta All in One Printer, perform Gradation Adjust.
What to do if Konica Minolta All in One Printer controller fails to start?
If the Konica Minolta All in One Printer controller fails to start, turn OFF the Main Power Switch and turn it ON again more than 10 seconds after. If the problem persists, replace the MFP Control Board (PWB-MFP).
How to fix faulty controller hardware on Konica Minolta BIZHUB C250 All in One Printer?
To fix faulty controller hardware on your Konica Minolta All in One Printer, change the MFP Control Board (PWB-MFP).
What to do if Konica Minolta All in One Printer cannot receive messages due to paper or toner issues?
If the add paper icon is lit, the Konica Minolta All in One Printer is out of paper and received documents are stored in memory. Add paper. In case of paper jam, received documents are stored in memory, so remove the jammed paper. Also, replace the toner bottle immediately if the machine is out of toner.
How to troubleshoot Konica Minolta All in One Printer when it cannot send messages?
To address the issue of not being able to send messages with your Konica Minolta All in One Printer, first, check the transmission procedure and try sending again. Then, print out the Abbreviated Dialing List to verify the number is registered correctly and correct any errors. Also, check the settings for any errors and correct them if needed. Ensure the telephone line is properly connected. If problems persist, telephone the destination to check for any issues on their end.
Why Konica Minolta BIZHUB C250 All in One Printer cannot receive messages?
General| Print Speed | 25 ppm |
|---|---|
| Print Resolution | 600 x 600 dpi |
| Scan Resolution | 600 x 600 dpi |
| Copy Speed | 25 cpm |
| Copy Resolution | 600 x 600 dpi |
| Fax Speed | 33.6 Kbps |
| Functions | Print, Copy, Scan, Fax |
| Duplex Printing | Yes |
| Connectivity | Ethernet, USB |
| Paper Size | A4, A5, B5 |
To Next Page
