How to fix error message 'Cannot connect to the network' on Konica Minolta All in One Printer?
If you receive an error message stating 'Cannot connect to the network' on your Konica Minolta All in One Printer, it indicates a connection to the network could not be established. Verify that the network cable is correctly connected and that the 'Network Settings' parameters have been correctly specified.
What to do if the message 'Misfeed detected' appears on Konica Minolta All in One Printer?
If the message "Misfeed detected." appears on your Konica Minolta All in One Printer, it means a misfeed occurred during printing. Check the illustration displayed with the error message to determine the misfeed location, then clear the misfeed following the appropriate procedure.
What to do if the message 'Replenish paper' appears on Konica Minolta All in One Printer?
If the message "Replenish paper." appears on the Konica Minolta All in One Printer, it indicates that a tray has run out of paper during printing. Check the touch panel to see which paper tray is highlighted, and then load that tray with paper.
How to fix Konica Minolta All in One Printer that does not start?
If your Konica Minolta All in One Printer does not start when the main power switch is turned on, check the following: 1. Ensure the power supply plug is correctly inserted into the electrical outlet. 2. Make sure the sub power switch is turned on.
Why copying does not start on my Konica Minolta All in One Printer?
If copying does not start on your Konica Minolta All in One Printer, check if the upper right-side door of the machine is securely closed. Also, ensure that you have loaded paper of the appropriate size into the paper tray.
How to fix light printed output on Konica Minolta All in One Printer?
If the printed output from your Konica Minolta All in One Printer is too light, it could be due to the copy density being set too light or the paper being damp. To fix this, touch [Dark] in the Density screen to copy at the desired copy density or replace the paper with new paper.
How to fix dark printed output on Konica Minolta All in One Printer?
If the printed output from your Konica Minolta All in One Printer is too dark, it could be because the copy density is set too dark, or the original was not pressed close enough against the original glass. Touch [Light] in the Density screen to copy at the desired copy density. Also, position the original so that it is pressed closely against the original glass.
Why is the printed output blurry on my Konica Minolta All in One Printer?
If the printed output from your Konica Minolta All in One Printer is blurry, it could be due to damp paper or the original not being pressed closely against the glass. Replace the paper with new paper and ensure the original is positioned so that it is pressed closely against the original glass.
What does 'Misfeed detected. Remove paper from part indicated by the circle' mean on Konica Minolta All in One Printer?
If the message "Misfeed detected. Remove paper from part indicated by the circle." appears on your Konica Minolta All in One Printer, it means the machine is unable to make copies due to a paper misfeed. Remove any misfed paper.
What to do if 'Properly close the section(s) indicated by the arrow(s)' appears on Konica Minolta All in One Printer?
If the message "Properly close the section(s) indicated by the arrow(s)." appears on your Konica Minolta All in One Printer, it indicates that a machine door or cover is open, preventing copies from being made. Ensure that all doors and covers are closed.
General| Brand | Konica Minolta |
|---|---|
| Model | bizhub C200 |
| Category | All in One Printer |
| Language | English |
To Next Page