1312 Getting up and running
GETTING UP AND RUNNING
Inserting batteries
Insert the batteries as indicated on the diagram on the inside of the bat-
tery-chamber door. Confirm the positive and negative battery terminals
are oriented correctly.
To open the battery-chamber door, slide the door toward the side of the
camera (1) to release the safety catch. Lift the door to open (2).
This digital camera uses four AA-size alkaline or Ni-MH batteries. Do not use other types of AA bat-
teries. The camera should be off when replacing batteries.
Close the battery-chamber door and slide it toward the body (3) to
engage the safety catch.
After installing the batteries, the set-time/date message may appear on
the monitor. The clock and calendar are set in section 2 of the setup
menu (p. 18).
Always keep the strap around your neck in the event that the camera is accidentally dropped. An
optional leather neck strap, NS-DG1000, is also available from your Konica Minolta dealer.
Availability varies with region.
Attaching the strap and lens cap
Using your thumb and index finger, pinch the outside tabs
of the lens cap to remove or attach. When the camera is
not in use, always replace the lens cap.
Pass one of the small loops of the lens-cap strap through the eyelet on
the lens cap (1). Pass the other loop through the first loop and tighten
(2).
Pass the end of the neck strap through the lens-cap strap and strap eyelet
on the camera body (3).
Thread the strap through the inside of the buckle
as shown (4). Repeat with the other end of the
strap.
2
3
1
4
1
2
3
Camera notes
After initially inserting a charged battery, do not remove it from the camera for twenty-four
hours; the camera can be off during this period. The main batteries are used to charge an
internal battery, which protects settings when the camera is turned off.
To Next Page
Loading...
Need help?
Image Sensor
Display
