Konig CMP-UPS500 User Manual (English)

Other manuals for Konig CMP-UPS500

Questions and Answers:

E
Elizabeth SteeleAug 11, 2025
Why is my Konig CMP-UPS500 UPS always in battery mode?
- A
  Allen DeanAug 11, 2025
  Your Konig UPS might be in battery mode due to several reasons. The power cord could be loose (try replacing it). The mains fuse might have blown (replace the mains fuse). It is possible that the mains voltage is too high, too low, or has failed (this is a normal state). Finally, the circuit board could be defective, in which case you should replace the circuit board and call for service.
M
Marc ParrishAug 18, 2025
What to do if my Konig UPS keeps beeping?
- E
  Emma BrownAug 18, 2025
  If your Konig UPS is beeping continuously, it indicates an overload. Try removing non-essential devices connected to the UPS to reduce the load.
A
Ashley RobertsAug 27, 2025
How to fix Konig CMP-UPS500 not turning on, with the display off?
- W
  William DanielsAug 27, 2025
  If your Konig UPS isn't turning on and the display is off, make sure you press and hold the POWER button for longer than 4 seconds. If that doesn't work, the circuit board may be defective and requires replacement. In this case, call for service.
A
Autumn ChavezSep 2, 2025
Why Konig CMP-UPS500 UPS doesn't provide the expected runtime?
- K
  Kathryn FrancisSep 2, 2025
  If your Konig UPS isn't providing the expected runtime, and you're getting low battery warnings too soon, the battery might be weak due to wear or repeated power outages. Allow the UPS to charge for at least 8 hours. If the problem persists after repeated testing, the battery should be replaced.