Need help?Do you have a question about the Konig CMP Series and is the answer not in the manual?
Inspect the UPS upon receipt and install in a protected area with adequate airflow, away from direct sunlight and dust.
Connect the AC input power connector to utility power and plug loads into the output connectors on the rear of the UPS.
The UPS battery recharges completely after approximately 8 hours of normal operation.
Press and hold the POWER button for more than 4 seconds to switch the UPS on or off.
In normal utility power, push the POWER button less than 1 second to perform a battery capacity self-test.
Learn about Backup (slow alarm), Low Battery (rapid alarm), and Overload (continuous alarm) states.
UPS batteries last 3-6 years; replacement and servicing should be done by knowledgeable personnel.
Charge battery every 3 months during extended storage and disconnect power to avoid overcharge.
Addresses problems like UPS not turning on, always at battery mode, or continuous beeping.
Details input voltage range, frequency, and output voltage/frequency specifications.
Includes battery type, capacity, backup time, recharge time, and audible noise levels.
Provides unit size, weight, operating temperature, and humidity limits.
To Next Page
General