Why is my Konig CMP-UPS650 UPS always in battery mode?
Your Konig UPS might be in battery mode due to several reasons. The power cord could be loose (try replacing it). The mains fuse might have blown (replace the mains fuse). It is possible that the mains voltage is too high, too low, or has failed (this is a normal state). Finally, the circuit board could be defective, in which case you should replace the circuit board and call for service.
What to do if my Konig UPS keeps beeping?
If your Konig UPS is beeping continuously, it indicates an overload. Try removing non-essential devices connected to the UPS to reduce the load.
How to fix Konig UPS not turning on, with the display off?
If your Konig UPS isn't turning on and the display is off, make sure you press and hold the POWER button for longer than 4 seconds. If that doesn't work, the circuit board may be defective and requires replacement. In this case, call for service.
Why Konig CMP-UPS650 UPS doesn't provide the expected runtime?
If your Konig UPS isn't providing the expected runtime, and you're getting low battery warnings too soon, the battery might be weak due to wear or repeated power outages. Allow the UPS to charge for at least 8 hours. If the problem persists after repeated testing, the battery should be replaced.
General| Power Rating | 650 VA |
|---|---|
| Output Waveform | Simulated Sine Wave |
| Power Output | 390 Watts |
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Battery Capacity | 7 Ah |
| Battery Recharge Time | 8 hours |
| Number of Outlets | 4 |
| Transfer Time | ≤10 ms |
| Communication Interface | USB |
| Surge Protection | Yes |
To Next Page
