KONVEKTA StreamLine SL800

Questions and Answers

Z
zhangjamieAug 18, 2025
What to do if KONVEKTA Air Conditioner is not running?
- S
  Steven MoonAug 19, 2025
  What to do if your KONVEKTA Air Conditioner is not running? Here are a few things you can check: * First, make sure that the thermostat is properly set. * Second, check the electrical connections at the switchboard. * Third, inspect the relay and replace it if necessary. * Fourth, check the evaporator blower and replace it if necessary. Also, consider cleaning the evaporator coil with compressed air or checking the connections at the magnetic clutch. If none of these steps work, it may be necessary to have a professional inspect the unit for more serious issues like compressor problems or refrigerant leaks.
J
johnatkinsAug 28, 2025
How to fix loud noise at compressor in KONVEKTA Air Conditioner?
- D
  Darryl MooreAug 28, 2025
  If you notice a loud noise at the compressor of your KONVEKTA Air Conditioner, it could be due to a defective bearing. In this case, you should replace either the bearing or the entire compressor. Another possible cause is a slack V-belt. Check the V-belt at the compressor drive to resolve this issue.
B
Bryan Lopez Jr.Nov 8, 2025
Why is my KONVEKTA StreamLine SL800 not running?
- J
  Jason WoodNov 8, 2025
  If your KONVEKTA Air Conditioner isn't running, several factors could be the cause. It might be due to an open thermostat; in this case, check the inside temperature and readjust the thermostat. Another potential reason is a disconnected electrical connection; inspect the electrical connections at the switchboard. A defective relay could also be the culprit, so examine the relay and replace it if needed. If the defrost thermostat has switched off, check the evaporator blower and replace it if necessary. Low outside temperatures can cause icing of the evaporator, so switch to ventilation only. A dirty evaporator coil can also prevent the AC from running; clean it with compressed air. Problems with the magnetic clutch, such as loose connections, should be checked. If the compressor isn't com...