CONTINUOUS DRAINAGE
Continuous drainage
If you want to drain the water into a larger tank, you can use the continuous drainage function. In this case,
proceed as follows:
1. Always ensure that the plug of the power cable is disconnected from the power socket;
2. Remove the water tank as previously indicated;
3. Locate the hose connection on the top left;
4. Correctly connect the hose in the package;
5. Place the opposite end of the hose inside the chosen tank (container).
NEVER PLACE THE PIPE UPWARD, BUT ONLY DOWNWARD TO ALLOW THE COLLECTED WATER TO DRAIN AWAY.
6. Connect and then operate the device.
WARNING!
DO NOT POINT THE END OF THE HOSE FROM WHICH THE WATER FLOWS DIRECTLY ONTO THE FLOOR AND/OR
ELECTRICAL CABLES! DANGER OF INJURY AND ELECTRIC SHOCK!
IN THIS MODE, CONSTANTLY MONITOR THE DEVICE TO AVOID UNCON- TROLLED WATER OUTPUTS! DANGER OF
INJURY!
START THIS MODE ONLY AT TEMPERATURES NOT LESS THAN AMBIENT TEMPERATURES
To Next Page
Loading...
