ELECTRIC SHOCK HAZARD!
THIS APPLIANCE IS DESIGNED TO OPERATE ON ALTERNATING
CURRENT ONLY. BEFORE PUTTING IT INTO SERVICE, MAKE
SURE THAT THE MAINS VOLTAGE CORRESPONDS TO THAT ONE
INDICATED ON THE DATA PLATE.
THE APPLIANCE MUST BE CONNECTED ONLY TO POWER
OUTLETS HAVING A MINIMUM CAPACITY OF AMPS.
DO NOT PULL THE POWER CORD OR THE APPLIANCE ITSELF TO
REMOVE THE PLUG FROM THE POWER OUTLET.
UNWIND COMPLETELY THE POWER SUPPLY CABLE BEFORE
OPERATING THE APPLIANCE.
DO NOT MAKE CONNECTIONS THROUGH EXTENSION CORDS OR
DOUBLE PLUGS.
NEVER LET THE POWER CORD RUN ON SUSPIGENT SHARP
EDGES, AVOID CRUSHING IT.
DO NOT LEAVE THE DEVICE EXPOSED TO THE ELEMENTS RAIN,
FROST, SUN, ETC..
DO NOT USE THE DEVICE:
WITH WET OR DAMP HANDS;
IF IT HAS BEEN DROPPED AND HAS OBVIOUS BREAKS OR
MALFUNCTIONS;
IF THE ELECTRICAL POWER PLUG OR CORD IS DEFECTIVE;
IN HUMID OR GASSATURATED ENVIRONMENT
DO NOT COVER THE DEVICE WITH TOWELS, CLOTHING, ETC.
SET THE DEVICE ONLY ON HORIZONTAL AND STABLE PLANES.
ALWAYS REMOVE THE PLUG FROM THE POWER SUPPLY
IMMEDIATELY AFTER USE AND BEFORE PERFORMING ANY
To Next Page
Loading...