NAME OF PARTS
Water box
Door seal
Filter screen
Footing
Door
Control panel
Top cover plate
Heat exchanger door cover
Attached accessories
Instructions
Drying rack
Drain pipe
INSTALLATION METHOD
The clothes dryer must be properly installed by qualified professionals to ensure use safety.
The user shall be responsible for the service caused by poor and incorrect installation.
1) Precautions before installation
Installation environment
- It is recommended to installed in an embedded space. please reserve the minimum
installation clearance for the drver:
25 mm at the top. zu mm at the lett and right sides and bu mm at the bacK.
Installation requirements
- Please install the dryer in a dry and well ventilated place with flat and solid ground. Do not
place it on carpet. cardboard. or place with direct sunlight
- The working environment temperature of the drver is 5°C-35°C. Do not place it below 0°C
or at a high temperature. The appiance performs best at a room temperature of 23 °C ~ During
handling. the inclination angle of the dryer shall not exceed 45°: after handling.
it needs to stand for more than 2 hours
- The arver shall not be placed next to the oven stove and other high-temperature
equipment, nor next to the refrigeration equipment. The back of the dryer must be well ventilated.
tis recommended that the clothes drver and washing machine be placed close to each other to
facilitate clothes dehvdration after washing dehvdration
Install the appliance on a flat hard floor Allowable slone under the appliance is 1 dearee
To Next Page
Loading...