Kooper 5917131 - Method of Use

 
METHOD OF USE
(1) Knob
- It is used to turn the power on/o. In case of shut down during operation, rotate the knob to “OFF”.
- The dry will automatically shut down after the program ends. If there is no operation within 2
minutes in the standby mode, the dryer will shut down automatically.
- It is used for program selection. Please refer to [Program guide] for program introduction.
(2) Start Pause
- Press the “Start Pause” keyt o pause or start the program.
- When the program is suspended, the set functions cannot be changed. If the program or function
needs to be changed during operation, or the power is o during operation and the power needs to
be powered on again, turn the knob to “O”, then turn the knob again to select the required program
and function, and finally start it.
(3) More Time
-Before the program starts, this function can add drying time of the program. Press continuously to
cycle through the set tap positions. Dierent programs have dierent tap position settings.
(4) Less Time
- Before the program starts, this function can reduce drying time of the program. Press
continuously to cycle through the set tap positions. Dierent programs have dierent tap position
settings.
(5) Anti crease
- If the clothes cannot be taken out in time after drying, select the anti crease program. At this time,
the inner drum rotates intermittently to prevent clothes from creasing.
- Touch any key or open the door to exit the anti crease mode. If there is no operation, the longest
execution will end automatically after 12 h by default.
(6) Dry level
- For selection of drying eect. The default option is and press the dry level key to