2) Adjustable foot
Press the diagonal on the top of the dryer to confirm whether the dryer is in a stable state.
- If the dryer shakes, rotate the four adjustable feet at the bottom to adjust them to the appropriate
height to ensure that the dryer is in a stable state.
- Never try to correct any unevenness in the floor with pieces of wood, cardboard or similar
materials under the appliance.
3) Installation of the drain pipe
Usually, the condensate water after drying is stored in the water box, and the water box needs
to be emptied after each program. If the installation position of the dryer is close to the sewer, or
the clothes dryer is stacked on the washing machine, the attached drain pipe can be installed to
discharge the water directlyto the sewer.
- Remove the connecting pipe at the rear of the water box, and install the drain pipe among the
attached accessories to this position (as shown in the figure). Please confirm that the installation
connector is firmly connected.
Please insert the other end of the drain pipe into the floor drain without twisting or flattening. If the
pipe is too long, please cut o the excess part.
- The drain pipe shall not be higher than the dryer, otherwise the water cannot be drained.
- Do not place the drain in accumulated water, which may cause backsuction.
- After the drain pipe is installed in place, the condensate water can be discharged directly without
emptying the water box after each use.
To Next Page
Loading...