1. Open the door and
take out the filter
screen from the front
support.
3. After drying
the filter screen,
reassemble it.
4. Install the filter
screen to the front
support.
2. Open the filter screen and
clean the flu of the two-layer
filter screen with a wet towel or
flowing water.
NOTA:
- There is a temperature sensor at the bottom of the front support. After the lint and ebris filter
screen is taken out, please be careful not to touch it to avoid scratching. When reinstalling the filter
screen, install in the correct direction and at the correct position.
- Do not use this dryer when the filter screen is not installed correctly.
4) Cleaning of water box
- If the drain pipe is not installed, the condensate water after drying is stored in the water box.
Please drain o it in time after program ends.
- During running, if the water box is full, n the display flashes for prompt, please empty the
water box immediately.
- The condensate water is not edible.
1. Take out the water box horizontally to
avoid spillover of condensate water.
2. Dump the condensate water and
reinstall the water box in place.
Water outlet
To Next Page
Loading...