31
▪ Sleep(hour): You can select the hours of operation before switching to standby
mode. When the device switches to low-power mode, the display shows the current
time (to remove the time display, set the Auto Standby Time to Off).
▪ Timer Setting: You can set different viewing timers (the device turns on and displays
the selected channel) or edit existing ones.
▪ Power ON/OFF: You can activate a scheduled Power ON and a scheduled Power
OFF.
2.5 Option
To access the menu, press the button MENU and then, using the arrow [Vol+/Vol-],
select Option. Using the arrow [CH+/CH-] you can select the sub-menu (OSD
Language, EPG Language, Subtitle Language, TTX Language, First Audio
Language, Second Audio Language, Digital Audio) and press OK to open the
selected item or using the [Vol+/Vol-] you can directly change the settings. Press
EXIT to exit the menu.
▪ OSD/EPG/Subtitle/TTX Language: Allows you to select the language used in the
OSD, in the Primary / Secondary Audio and in Teletext.
▪ First/Second Audio Language: Allows you to select the audio stream for 1
st
/2
nd
Audio language.
▪ Digital Audio:
2.6 System
To access the menu, press the button MENU and then, using the arrow [Vol+/Vol-],
select System. Using the arrow [CH+/CH-] you can select the sub-menu (Parental
Guidance, Lock Control, Factory Reset, System Information, Software
Upgrade, Network Setting, Power On Control) and press OK to open the selected
item or using the [Vol+/Vol-] you can directly change the settings. Press EXIT to exit
the menu.
▪ Parental Guidance: Once the password has been entered, you can select the age
rating limit (Lock Control->Channel Lock= On) to request the password in order
to watch a channel and protect your children from inappropriate content. You can also
type a new password by typing it 2 times. The default password is "0000".
▪ Lock Control: If Channel Lock=ON the user must enter a password when a
channel is under a forbidden rating. If Menu Lock=ON the user must enter a
password before change some menu settings. You can also type a new password by
typing it 2 times (Change Password). The default password is "000000".
▪ Factory Reset: Allows a reset to the initial conditions.
▪ System Information: Information about the firmware, hardware used by the device
is displayed.
To Next Page
Loading...
