Korg DSS-1 - Page 8

NOTE:
1. Parameter No.: Parameter number used for program parameter change.
Offset: Byte offset within program parameter dump.
Numbers within parentheses are parameter numbers used when editing
within the DSS-1.
2. Must be set for both oscillators so that OSC1 + OSC2 = 100.
3. DDL TIME Format
LOW
HIGH
4. The MAX BEND RANGE value is limited to the range of 0 to 12, derived by
subtracting from 12 the larger MAX INTERVAL value of the multisounds
assigned to OSC1 and OSC2. This must be reset if there is a change in the
multisound MAX INTERVAL.
Scan by Manual Manor
http://www.markglinsky.com/ManualManor.html