Korg DW-6000 - OSC2 VCA Level Check; Resonance Level and fo Check; fc Slope Check; Noise Level Check

6
Tape
Interface
LOAD
Procedure
This procedure
is used
to
put
recorded
memory.
data
bacl< into
the
DW-6000's
internal
a]
Connect the DW-6000 rear panel FROM TAPE jack to
the output jack (earphone, line out, etc.) of your
recorder.
Set the
LOW/HIGH switch
to
match your tape
recorder's
output
signal level.
#
E
Recorder output
jack