Korg DW-6000 - Page 48

DA1A
DUMP
REFERENCE
IINTERFACE
WITH
PERSONAL COMPUTER
When
using a computer for DW-6000 control and
communications, a system exclusive message and the following data types are
employed.
DEVICE ID
WRITE COMPLETED
WRITE ERROR
: Identifies
tiie
equipment. Sent upon
receiving a DEVICE ID REQUEST.
: Sent
in response to a
WRITE REQUEST,
this indicates that the PROGRAM WRITE
task has been
successfully completed.
: Sent in response to a
WRITE
REQUEST,
this means that the
synth is set
to
the
WRITE DISABLE mode so PROGRAM
WRITE task cannot be completed.
DATA SAVE (DATA DUMP):
In response
to
a DATA SAVE REQUEST,
this sends the data for the sound
^
—
s^
presently
being produced.
The
above examples require that the DW-6000 and com-
puter
interface be connected via their
respective MIDI IN
and
MIDI OUT Jacks as shown here.
Rte^iKS;;
DEVICE ID REQUEST : A request
for the
equipment's MIDI iden-
tification
number.
WRITE REQUEST : A request for the DW-6000 to
write
data
for the present sound to program
memory.
DATA SAVE
REQUEST
: A request for the DW-6000 to send data
for the present
sound.
PARAMETER CHANGE
:
Used to
change parameters of the cur-
rent sound.
CompulGr
I