Assembling the stand 43
11 Connect the pedal and power leads to the corresponding piano connectors.
12 Place the piano in the location where it will be played. Regulate the screwable
pedal-adjuster (d) underneath the pedals, so that it touches the ground.
13 Tighten and check all the screws and bolts.
Be careful not to pinch the power cable under the piano feet.
Check after assembly
[•] Are any parts left over?
If any parts are left over, check the diagrams to see where they should be used.
[•] Make sure that all screws and bolts are tight.
d
To Next Page
Loading...
