73
5. Pattern mode
1. Press step key 1 of group 1 (select LED 1 lit).
2. Continue holding down step key 1, and press step key 5. Step keys 1
through 5 will be selected for chain play, and will all light.
While chain play is playing back, you can press the RESET/ERASE
key to play the currently-playing pattern from its beginning.
To stop chain play, either re-select Pattern Set, or defeat “hold” for
the Pattern Set function
Assigning a pattern to a Pattern Set
1. With playback stopped, hold down the Pattern Set key and press
the step key to which you want to assign a pattern.
2. While holding down the Pattern Set key, use the dial to select the
pattern number that you want to assign. To complete the assign-
ment, release the Pattern Set key.
3. Continuing to hold down the Pattern Set key, press the Write key
(the Write key will blink).
4. The display will ask “PtSetWr?” Use the dial to select “Yes” and
press the Write key to save the data. If you decide to cancel, select
“No” or press the STOP/CANCEL key.
You will be unable to write if the Global mode Memory Protect set-
ting (☞p.83 “Protecting the data in memory”) is on. In this case, turn
off the Global mode Memory Protect setting before you write.
Never turn off the power while data is being written. The data may be
lost if you do so.
To Next Page
Loading...
Need help?
General
