13 KARMA Getting Started Guide
5. Press [F8] (Open), and then press [F2] to view the MIDI I/O tab. Look to see which output MIDI channels are being
used - these are the Tracks that need to be set to “REC” on the main Sequencer page.
Note: If more than one Track is listening to the same GE you don’t need to record-enable them both, only the first one is
needed.
Note: If none of the Output tracks are set to MIDI channel 1 (the Input channel) then when you go back to the main
sequencer page be sure that you select the first track that IS on MIDI channel 1 to be your current recording track.
To do this exit from the Menu and then press [F1] (Play.REC). Cursor to T01 and use the Data Entry controls to
select the track needed.
Try sequencing with Combi B053 Ministry of Dance to experiment with a setup that requires these steps. It
requires Tracks 1,3 and 4 to be record-enabled, and the current recording track to be Track 5. Note that Track 5
doesn’t need to be record-enabled since no data is being output to MIDI channel 1, but it is the correct track to
send MIDI into the KARMA GE’s. Got it?
To Previous Page
Loading...
