10
KingKORG Owner’s manual
Rear panel
SWITCH/PEDAL jack
You can connect a pedal switch or foot
controller here.
MIDI IN/OUT connectors
These connectors allow
the KingKORG to exchange
MIDI messages with an
external MIDI device.
USB B connector
This connector allows the KingKORG
to exchange MIDI messages with your
computer.
CV/GATE OUT jack
This outputs a control voltage and gate.
By connecting this to an analog synthesizer
you can control it in various ways.
Mic jack
You can connect a mic here.
Vocoder-type programs use this mic
as the modulator audio.
DAMPER jack
You can connect a damper pedal here.
AUDIO OUTPUT jacks
You can connect powered monitors, a stereo
amp, mixer, or multi-track recorder to these
jacks. If you’ re using a monaural connection,
connect the L/MONO jack.
Power switch
This turns the power on/off.
DC12V jack
Connect the included AC adapter
here. Connect the AC adapter to the
KingKORG before you plug it into
an AC outlet.
Cable hook
To prevent the power cord from being
accidentally pulled out of the DC12V jack,
fasten the cable around this hook.
Note regarding power (the Auto Power-Off function)
This instrument is equipped with an auto power-off function.
The power will turn off automatically if a certain length of time
elapses without any user input. (With the factory seings, the
power will turn off when four hours have elapsed without any
user input.)
To disable this, change the seings of the GLOBAL
“
g15: Power Off
”
page.
To Next Page
Loading...
Need help?
General
