Korg M50-73 - Settings for the Entire M50; Global Mode Structure and Basic Setup

Using the arpeggiator while you play Other settings for the arpeggiator
77
Program
Combination
Sequencer
EffectArpeggio
Drum Track
GlobalMedia
Other settings for the
arpeggiator
You can also set Gate , Velocity , Swing , and Scan Zone .
These parameters are set in Prog P7: ARP/DT– ARP
Setup page, Combi P7: ARP/DT– Arpeggiator A, B
page (see PG page 59, page 107 and page 168).
Linking the arpeggiator to
program, combinations
You can specify whether the arpeggiator settings
written in a program or combination will change when
you switch programs or combinations, or whether the
arpeggiator status will not change when you switch
programs or combinations.
With the factory settings, the former is selected. Use
the latter when you want to keep the same arpeggio
pattern running, and change only the program sound.
This setting is made in “Load ARP when changing”
(Global P0: Basic Setup, Basic page). (See PG page 217)
Arpeggiator synchronization
For details on synchronization between arpeggiators A
and B, synchronization with the drum track function,
and synchronization between the arpeggiators and
sequencer in Sequencer mode, please see PG page 174.
Creating a user arpeggio
pattern
Arpeggio patterns that you create can be written to
U0000(INT)–U1027(USER).
These can be created in Global P6: Arpeggio Pattern.
(See PG page 246)