Korg monotribe - Global Settings Menu; Auto Power-Off Setting; Battery Type Setting; SYNC OUT Polarity Setting

16
Saving a sequence
When the sequencer is not playing back and the monotribe is not pro-
ducing sound, hold down the REC button until the REC LED stops
blinking and goes dark.
The saved sequence will be loaded at the next power-up. To change
this, you’ll need to adjust the settings located in the Global menu (p.16).
Never turn off the power while data is being saved. Doing so may
destroy the internal data.
The saved settings are remembered even when the power is off.
Global menu
Here you can adjust various settings for the monotribe. These set-
tings are assigned to step buttons 1–7 (see the table below).
Step button 1 Auto power-off
LED Unlit Auto power-off is disabled.
* LED Lit Auto power-off is enabled.
Step button 2 Battery type selection
* LED Unlit The monotribe is optimized for alkaline batteries.
LED Lit The monotribe is optimized for nickel-metal hy-
dride batteries.
Step button 3 SYNC OUT polarity
* LED Unlit The output will rise at the beginning of each step.
LED Lit The output will fall at the beginning of each step.
Step button 4 SYNC IN polarity
* LED Unlit The step will advance when the input signal rises.
LED Lit The step will advance when the input signal falls.
Step button 5 Sequence settings at start-up
LED Unlit The initial sequence will be loaded at power-on.
LED Blinking The saved sequence will be loaded at power-on.
* LED Lit The demo sequence will be loaded at power-on.
Step button 6 Drum preview
LED Unlit Nothing will sound when you press one of the drum
sound generator part buttons.
* LED Lit The corresponding drum sound will be heard when
you press one of the drum sound generator part
buttons.
Step button 7 TEMPO knob range
LED Unlit The TEMPO range will be narrow.
* LED Lit The TEMPO range will be wide.
* indicates the factory default setting.
Setting procedure
Press the corresponding step button to make the setting.
1. While holding down the ACTIVE STEP button and the GATE TIME
button, turn the power on. The monotribe will enter Global Menu
mode.
2. Press the step button for the setting that you want to change. The
LED will indicate the setting.