Korg Nu:Tekt OD-S - Recommended Settings; Normal Overdrive Settings; Tube Overdrive Settings; Hard Drive Settings

- 11 -
Recommended Settings
Normal OVERDRIVE
This is a typical overdrive setting.
If you want more of a vacuum tube sound (a milder sound), turn the TUBE GAIN knob to maximum, and
adjust the distortion using the GAIN knob.
If you want a harder sound, turn the GAIN knob to maximum, and adjust the distortion using the TUBE GAIN
knob.
WIDE
ON
OFF
Tube OVERDRIVE
This is a full-range overdrive effect that emphasizes the tube sound.
Turn the WIDE switch on the circuit board ON, and adjust the distortion using the GAIN knob.
WIDE
ON
OFF
Hard Drive
This is a sound with hard distortion.
If your amp is already distorted, turn the GAIN knob lower than the figure.
WIDE
ON
OFF